Yanmar SV26 User Operation And Maintenance Manual page 66

7.18.1 Mechanical quick coupler ARDEN EQUIPMENT
Quick coupler structure
Dismantling the accessory
Mounting the accessory
1. Place the accessory on a stable, flat surface.
2. Clean all the parts.
3. Be equipped with the wrench supplied with the accessory and insert it into the quick coupler
hole.
4. Turn the key to unlock the quick coupler (1).
5. Remove the key and store it.
6. Place the arm equipped with the quick coupler on the accessory to engage the accessory
hooks on the bucket or accessory pin.
7. Rotate the quick coupler slowly lifting the boom to fully engage the quick coupler to the buc-
ket or accessory.
8. Manoeuvre the bucket or accessory to low height from the ground to see if it is locked in the
quick coupler.
Note
Check that the indicator is in the locked position.
The quick change system is composed of:
A= Fastening hooks
B= Locking pins
C= Locking screw
1. Park the machine preferably on a stable,
flat and level surface.
2. Place the accessory at about 5 cm above
the ground.
3. Be equipped with the wrench supplied
with the accessory and insert it into the quick
coupler hole.
4. Turn the key (1) to disengage the bucket
or accessory locking pin.
DANGER
By pressing the key, the bucket or acces-
sory detaches and comes into contact
with the ground. Take care not to get
your hands or feet crushed by the bucket
or accessory.
5. Remove the key and store it.
6. Retract the bucket cylinder to disengage
the rear of quick coupler.
7. Slowly remove the boom from the ma-
chine to completely free the quick coupler
from the bucket or accessory.
7 Options
49