Table of Contents
Advertisement
15 Transporting the machine
1. Check the condition of the transport vehicle surface. If the surface is greasy, it must be
cleaned before installing the machine on the transport vehicle.
Note
If the transport vehicle surface is steel, provide a non-slip mat or spacers to prevent the
machine tracks from slipping.
4
2. Check the WLL
of the tie-down points of the transport vehicle, it must be at least the WLL
recommended for tying down the accessories.
D Lashing record, page 184
3. Check the location and condition of the machine tie-down points.
4. Tie-down the machine at the points provided for that purpose and that are indicated on the
machine. YANMAR CONSTRUCTION EQUIPMENT EUROPE recommends securing the ma-
chine according to the diagonal direct tie-down method respecting the angles shown below.
Angle
Value in degrees
α
20°-60°
β
10°-60°
3 Warning labels, page 6
If other tie-down methods are used, YANMAR CONSTRUCTION EQUIPMENT EU-
The driver must ensure that the angles α and β are determined so that there is no deflec-
Working Load Limit (WLL)
4.
116
IMPORTANT
ROPE does not guarantee the machine tie-down.
tion of the tie-down accessories.
4
Advertisement
Table of Contents
