Table of Contents
Advertisement
11 H
ANDLING OF ACCESSORIES
11.1 Hydraulic hammer SOCOMEC
Usage recommendations
During the work phase, keep everyone out of the 20m danger zone.
The hammer must be at 90° to the working surface.
•
In a submerged area, make sure that the water does not reach the body of the hammer.
•
Note
The hammer can only operate within the following temperature range:
[-5°C ~ +45°C]
•
To avoid damaging the structure of the hammer and minimize vibration, the operator must be
smooth when using the tool.Be sure to set the engine speed if you are using a hammer.
•
Once the work requiring the hammer is finished, set the hammer vertically with respect to the
ground and leave it in this position to facilitate drainage of condensation on the side of the
piston.
Tool change
Do the following operations with gloves and safety shoes.
•
Always use oils and greases recommended by YANMAR.
•
1. Park the machine preferably on a stable, flat and level surface.
2. Place the accessory at about 30 cm above the ground in horizontal position.
3. Stop the engine.
4. To remove the tool from the housing:
WARNING
IMPORTANT
IMPORTANT
105
Advertisement
Table of Contents
