7.9 Plug-in flashing light
Keep three points of support with the machine to complete the installation safely.
If three points of stable support are not available, use suitable equipment to operate the
•
To activate the flashing light attached to the rear of the cab, turn on the switch located in the
cab on the right of the driver's seat.
•
To attach the flashing light:
1. Remove the protective cap from the pin's tip.
2. Insert the tip of the flashing light in the pin and tighten the nut located at the base of the flash-
ing light.
7.10 Keypad immobilizer
•
The machine can be fitted when this option is requested.
•
The theft deterrent keypad consists of an immobilizer box and a keypad installed in the
cockpit.
•
For more information, consult the instructions supplied with the device.
DANGER
machine safely.
•
The machine can be fitted when this op-
tion is requested.
•
The beacon kit includes the beacon, its
electrical harness and its support, and a moun-
table switch in the cockpit.
1. Once the user code has been programmed,
type A, then the 4-digit code and press button
V.
Note
When the code is recognised, the
green light (to the left) will light up.
2. Then turn the starter key within 60
seconds.
7 Options
43