Table of Contents
Advertisement
10 H
ANDLING THE BUCKET
10.1 Machine stability when using with a bucket or an
accessory
•
The maximum weight when in use in bucket mode or with accessories ensure machine dy-
namic stability in use. It corresponds to the maximum weight allowed at the end of the empty
arm.
•
This weight is determined for the machine on a flat and firm ground under the most unfavour-
able conditions and is indicated in the table below.
1 Lifting SV26 Cabin, page 171
2 Lifting SV26 Canopy, page 172
•
It must absolutely be taken into account by the operator before using the machine for excava-
tion, levelling operations or in working conditions with the accessories.
•
Depending on the machine configuration (arm length, presence of a counterweight...) and
working conditions, the operator must make sure that :
– The equipment and accessories selection is made according to the nature of the task to be car-
ried out and according to the machine's stability limits.
– the total weight of the quick coupler, the accessories used (bucket, hydraulic hammer...) and
the load handled does not exceed the maximum weight allowed.
Any excess can lead to a loss of stability of the machine and tip it over. YANMAR CON-
STRUCTION EQUIPMENT EUROPE S.A.S. accepts no responsibility in case of non
compliance with the safety instructions described in this chapter.
1150 mm
1400 mm
370
330
405
380
1150 mm
1400 mm
330
300
380
345
DANGER
99
Advertisement
Table of Contents
