Initial Setup - Fujitsu ETERNUS DX S5 Series Configuration Manual

5. General Settings

Initial Setup

Initial Setup
This section describes the Initial Setup function for the ETERNUS DX.
This function performs the required initial settings that must be set before operating the ETERNUS DX on a series
of wizard screens.
●
Initial Setup 1
This function performs the minimum settings required before operating the ETERNUS DX on a series of
wizard screens.
●
Firewall Settings
Set the firewall for each service.
●
Initial Setup 2
Makes the reporting settings for when an error occurs in the ETERNUS DX on a series of wizard screens.
The settings can be omitted if the reporting function will not be used.
●
Smart Setup Wizard
With the ETERNUS DX, configure the settings that are required for access from the host (server) to Thin
Provisioning Volumes on a series of wizard screens.
Caution
• If the browser is shut down during execution of Initial Setup, other functions will no longer be
available.
In this case, forcibly log in using the same user ID, and perform Initial Setup 1 again from the
beginning. However, if you have already reached Initial Setup 2, the wizard is executed from the
beginning of Initial Setup 2.
• The available setting items depend on the role of the logged in user.
• If the system message "Currently Network Configuration is set to factory default." is displayed, the
network environment settings for the MNT port must be performed. The following functions in the
[Initial Setup 2] wizard are not displayed until the network environment settings are complete.
- Setup SNMP Agent Basic Interface
- Setup SNMP Manager
- Setup SNMP Agent MIB Access View
- Setup SNMP Agent User
- Setup SNMP Agent Community
- Setup SNMP Agent Trap
- Setup E-Mail Notification
- Setup Syslog
Note
• The [Initial Setup 1] wizard is displayed when a user with the required policies for this setting
performs the first login after installing the ETERNUS DX.
After the [Initial Setup 1] is complete and the user with the required policies logs in again, the
[Initial Setup 2] wizard is displayed.
For users without the required policies, the [Overview] screen is displayed at the first login.
• The settings made in the Initial Setup can be changed individually later.
75 Configuration Guide (Basic)