Fujitsu ETERNUS DX S5 Series Configuration Manual page 142

7. Host Interface Management
Modify Port Parameters
Note
• When the [Discovery] button is clicked for "IPv6 Connect IP Address", the IPv6 connect IP address
can be created automatically from the prefix value that is obtained from the router that is
connected to the ETERNUS DX and the input IPv6 link local address.
• When the [Discovery] button is clicked for "IPv6 Gateway", the gateway information can be
obtained from the connected router.
• When the port mode is "CA" or "CA/RA" and Multiple VLAN is enabled, click the [Add] button to
register up to 15 IP address information for each port.
• To check whether the IP address is allocated correctly and the connection status for the remote
device, click the [Test Connection (ping)] button for "IP Address", "IPv6 Link Local Address", or
"IPv6 Connect IP Address".
4
Click the [Modify] button.
5
A confirmation screen appears. Click the [OK] button.
Setting of the iSCSI port parameters starts.
6
Click the [Done] button to return to the [iSCSI Port] screen.
142 Configuration Guide (Basic)