Fujitsu ETERNUS DX S5 Series Configuration Manual page 41

3. Rack Installation
High-Density Drive Enclosure Installation
2
Attach the rack rails to the rack.
(1)
Insert the rack rails into the holes of the front and the rear rack pillars to lock the rail lock lever.
[Left]
(Rack pillar: front)
(2)
Use the M4 screws to fasten the front and the rear rack rails.
Use the washers to fasten the rack rails to the front and rear rack pillars.
Note
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any
space between them.
M4 screw
The M4 screw positions for the rack rails are determined by the high-density drive enclosure base
line.
Insert the M4 screws in the second holes on the front and rear rack pillars above the base line to
fasten the rack rails.
[Right]
Rack rail
(left)
Washer
Washer
M4 screw
(Rack pillar: front)
Rail lock lever
Washer
M4 screw
(Rack pillar: rear)
Rack rail
(right)
41
(Rack pillar: rear)
Washer
M4 screw
Configuration Guide (Basic)