Figure 3 Eternus Dx100 S5/Dx200 S5 Rear View Of A Controller (Reference) - Fujitsu ETERNUS DX S5 Series Configuration Manual

4. Connecting Cables
Host Interface Cable Connection
(1)
Remove the connector cover attached to the port of the SFP+ module and open the lever.
IMPORTANT
Keep the removed connector cover in a safe place where it will not be lost.
(2)
Check the direction of the SFP+ module and insert it all the way into the port cage of the host
interface.
Install the SFP+ module in Port#0 first, and then Port#1.
Figure 3
(3)
Close the SFP+ module's lever.
2
Connect a host interface cable to the ETERNUS DX.
Insert the host interface cable connectors in the host interface ports (iSCSI) of Controller 0 (CM#0) and
Controller 1 (CM#1).
SFP+ module
Lever
ETERNUS DX100 S5/DX200 S5 Rear View of a Controller (Reference)
Host interface Host interface
(CA#0) (CA#1)
Controller 0
(CM#0)
Port#0 Port#1 Port#0
SFP+ module (Insertion direction)
Topside
Host interface
(CA#0)
Port#1 Port#0 Port#1
48
Host interface
(CA#1)
Controller 1
(CM#1)
Port#0 Port#1
Configuration Guide (Basic)