Fujitsu ETERNUS DX S5 Series Configuration Manual page 102

5. General Settings
Initial Setup
The Smart Setup Wizard is started with one of the following ways.
After the completion of the Initial Setup 2 wizard, the [Smart Setup Wizard] screen appears.
•
Click the [System] tab and then click [Smart Setup Wizard] in [Action].
•
This section explains the procedure in which the Smart Setup Wizard is started from [Action] in the [System] tab
and "FC" is selected for the CA type. The procedure is similar for cases where "SAS" is selected.
Refer to "ETERNUS Web GUI User's Guide" for the procedure if the CA type is "iSCSI".
1
Click the [System] tab on the navigation of the ETERNUS Web GUI screen.
2
Click [Smart Setup Wizard] in [Action].
The [Start] screen of the Smart Setup Wizard appears.
3
Click the [Next >>] button.
If multiple CA types are installed, the configuration screen for the CA type selection
If only FC type CAs are installed, the configuration screen for the port setting
102
(Step 4) appears.
(Step 5) appears.
Configuration Guide (Basic)