Fujitsu ETERNUS DX S5 Series Configuration Manual page 35

3. Rack Installation
Controller Enclosure Installation
The M5 screw positions for the rack rails are determined by the controller enclosure base line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the 2nd
and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
6th hole
(M5 screw)
1st hole
(M5 screw)
5th hole
(M5 screw)
2nd hole
(M5 screw)
3
Tighten the M4 screws of the rack rails that were slightly unscrewed in
4
Install the controller enclosure in the rack.
5
Fasten the controller enclosure in the rack.
Use three M5 screws to fasten it in the rack pillar.
Controller enclosure: front
[Left]
2U
Controller
enclosure base line
Rack rail
Controller enclosure: rear
[Left]
2U
Controller
enclosure base line
Rack rail
• When installing or removing the controller enclosure to or from the rack,
make sure that the sides and the bottom of the controller enclosure are
held by two or more people. Failure to do so may cause injury.
[Right]
6th hole
(M5 screw)
1st hole
(M5 screw)
[Right]
5th hole
(M5 screw)
2nd hole
(M5 screw)
35
Step 1.
Configuration Guide (Basic)