Fujitsu ETERNUS DX S5 Series Configuration Manual page 31

3. Rack Installation
Power Distribution Unit Installation
M3 screw
M3 screw
3
Install the power distribution unit in the rack.
Use four M6 screws to fasten it in the rack pillar.
M6 screw
4
Attach the blank panel to the front side of the rack.
The blank panel should be attached at the same height as the power distribution unit.
Power distribution unit
(Rack pillar: rear)
Cable holder
M3 screw
M6 screw
Blank panel
(Rack pillar: front)
31
(Rack pillar: rear)
Configuration Guide (Basic)