Controller Enclosure Installation - Fujitsu ETERNUS DX S5 Series Configuration Manual

3. Rack Installation

Controller Enclosure Installation

Controller Enclosure Installation
This section describes how to install a controller enclosure in a rack.
1
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front and
rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be attached to the rack
before they can be completely tightened.
Loosen the M4 screws to
adjust the length of the
rack rails to match the
distance between the
front and rear rack pillars.
[Left]
(Rack pillar: front)
2
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the washers to fasten the rack rails
to the rear rack pillars.
Note
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any space
between them.
Plate
M5 screw
(Rack pillar: front)
Rack rail (left)
An "L" mark is on the
inner side.
Rack rail (right)
An "R" mark is on the inner side.
[Right]
Rack rail (left)
Plate
M5 screw
34
(Rack pillar: rear)
M5 screw
Washer
(Rack pillar: rear)
Rack rail (right)
M5 screw
Washer
Configuration Guide (Basic)