Drive Enclosure Installation - Fujitsu ETERNUS DX S5 Series Configuration Manual

3. Rack Installation

Drive Enclosure Installation

Drive Enclosure Installation
This section explains how to install a 2.5"/3.5" type drive enclosure in a rack.
IMPORTANT
Drive enclosures must be installed above the controller enclosure. When installing multiple drive
enclosures, install them in the order of the "DE_No. label" numbers that are attached to the drive
enclosures. The DE_No. labels are attached on the following locations.
Right end of the drive enclosure
as seen from the front
1
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front and
rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be attached to the rack
before they can be completely tightened.
Loosen the M4 screws to
adjust the length of the
rack rails to match the
distance between the
front and rear rack pillars.
[Left]
(Rack pillar: front)
2
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the washers to fasten the rack rails
to the rear rack pillars.
Top right of the drive enclosure
as seen from the rear
DE_No. label
Rack rail (left)
An "L" mark is on the
inner side.
Rack rail (right)
An "R" mark is on the inner side.
[Right]
37
(Rack pillar: rear)
Configuration Guide (Basic)