Preparation; System Configuration Example; Figure 1 System Configuration Example; Table 1 Server (Host) Environment - Fujitsu ETERNUS DX S5 Series Configuration Manual

2.

Preparation

This chapter explains the preparations necessary for configuring a system using the ETERNUS DX.

System Configuration Example

The example in this section is described by assuming that the system in
■
Configuration Diagram
Figure 1 System Configuration Example
A Administration
terminal
D Host server
Symbol Setting
A Administration terminal setup
B Event notification setting
C FC connection, iSCSI connection, and multipath connection
D SAN environment configuration
■
Server (Host) Environment
Table 1 Server (Host) Environment
Item
Server OS
Connection Configuration FC connection or iSCSI connection, duplicated with multipath connection
Multipath Driver
To connect the server and the ETERNUS DX via a switch, setting up of the switch must be performed. For details
on this setting, refer to relevant manuals of the switch.
B
E-mail server
C
FC connection
iSCSI connection
Multipath connection
D
ETERNUS DX
Explanation
Solaris, Linux, Windows, or VMware
ETERNUS Multipath Driver
B B
SNMP server
LAN for operation
B
Refer to:
"Preparation and Setup for the Administration Terminal"
(page 24)
"8. Monitoring Settings" (page 159)
"Server Connection Preparation" (page 24)
"6. Configuration Settings for RAID Groups or Thin
Provisioning" (page 108)
"7. Host Interface Management" (page 133)
23
Figure 1 is being configured.
Syslog server
management
Remote support
center
Configuration Guide (Basic)