Fujitsu ETERNUS DX S5 Series Configuration Manual page 43

3. Rack Installation
High-Density Drive Enclosure Installation
Rack rail
(right)
Stopper bracket B
M4 screw
(Rack pillar: rear)
The M4 screw positions for flap bracket A and B are determined by the high-density drive enclosure base
line.
Insert the M4 screws in the seventh and eighth holes above the base line to fasten the flap brackets.
Rear view of a high-density drive enclosure
[Left]
4U
5
Install the high-density drive enclosure in the rack.
6
Fasten the high-density drive enclosure in the rack.
Use four M5 screws to fasten it in the rack pillar.
Stopper bracket A
[Right]
Flap bracket B
7th & 8th
(M5 screws)
High-density drive
enclosure base line
Rack rails
• For safety and stability, use a lifter to install or remove high-density drive
enclosures in the rack.
(Rack pillar: front)
Rack rail
(left)
holes
43 Configuration Guide (Basic)