Fujitsu ETERNUS DX S5 Series Configuration Manual page 186

10. System Status Check
Powering Off
This section explains how to use the Power switch and the power synchronization unit to turn off the ETERNUS
DX.
For other procedures, refer to the related manuals.
■
When Controlling by the Power Switch
This section explains how to use the Power switch to turn off the ETERNUS DX.
1
Press the Power switch of the controller enclosure or the frontend enclosure for four seconds or more.
Controller enclosure
Frontend enclosure
The READY LED ( ) on the controller enclosure or the frontend enclosure is turned off.
IMPORTANT
• After power-off, wait for about one minute before turning power on again.
• If the Power switch is pressed again between the time of the READY LED ( ) turning off and the
POWER LED ( ) turning off, the ETERNUS DX power may turn on.
2
The power of the ETERNUS DX is disconnected.
When the power is disconnected, the POWER LED (
■
When a Power Synchronized Unit Is Used
If the server is turned off, the ETERNUS DX is also turned off.
Power switch
ETERNUS DX60 S5/DX100 S5/DX200 S5
Power switch
ETERNUS DX900 S5
Power switch
ETERNUS DX500 S5/DX600 S5
or ) of each enclosure is turned off.
186 Configuration Guide (Basic)