Fujitsu ETERNUS DX S5 Series Configuration Manual page 27

2. Preparation
LAN Connection Preparation for Operation Management
Usage
REMCS
(remote support)
AIS Connect (remote
support)
Syslog
(event notification and
audit log sending)
RADIUS
ping
KMIP (key
management)
ECD (*4)
¡: Possible / △: Partially possible / ´: Not possible
*1: Only the following functions are available:
• Checking the ETERNUS DX status
Switching the Master CM
•
*2: Modifiable
*3: May use either the MNT port or RMT port.
*4: Used with the Remote Installation function. ETERNUS Connection Detecting tool (ECD) is a Windows application for collecting the
network setting information of the ETERNUS DX.
For details on the port numbers for the ETERNUS SF Software, refer to the manual of each Storage Foundation
Software ETERNUS SF.
■
Communication Modes
The default LAN operation mode is "Auto Negotiation" which allows the ETERNUS DX to automatically recognize
1000BASE-T/100BASE-TX/10BASE-T and Full/Half-Duplex connections. However, some devices may require that a
fixed communication mode be set.
Port
Protocol tcp / udp
number
smtp tcp 25 (*2)
(client)
pop3 tcp 110 (*2)
(client)
http tcp 80 or 8080
(client) (*2)
https tcp 443
(client)
Syslog udp 514 (*2)
Radius udp 1812 (*2)
ICMP − −
SSL tcp 5696 (*2)
Unique udp 9686
protocol
Master CM
Direction
MNT RMT
to ¡ (*3) ¡ (*3)
to
¡ (*3) ¡ (*3)
to ¡ (*3) ¡ (*3)
to ¡ (*3) ¡ (*3)
to ¡ (*3) ¡ (*3)
to ¡ (*3) ¡ (*3)
from
¡ (*3) ¡ (*3)
to ¡ (*3) ¡ (*3)
from ´
¡
27
Slave CM
Remarks
MNT RMT
´ ´
Used for
failure
notificatio
n, etc.
´ ´ Used for
SMTP
authentica
tion
´ ´
Used for
firmware
download,
etc.
´ ´
—
´ ´
−
´ ´
−
´ ´ −
´ ´
−
´ ´ −
Configuration Guide (Basic)