Rear; Figure 23 Rear View Of A Controller Enclosure (When The Eternus Dx60 S5 Is Installed With Only One Controller); Figure 24 Rear View Of A Controller Enclosure (When The Eternus Dx60 S5 Is Installed With Two Controllers) - Fujitsu ETERNUS DX S5 Series Operation Manual (Basic

A. Component Names
Controller Enclosure

Rear

This section provides the names of the components in the rear of a controller enclosure.
■
ETERNUS DX60 S5
Figure 23 Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is installed with Only One
Controller)
1
2 3
PSU#0
1
Controller (CM#0) (refer to
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3
Host interface
This interface is used for connecting a controller with a server.
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5
RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7
Cover
Remove this when installing an additional controller (optional).
8
Power supply units (PSU#0, PSU#1) (refer to
Figure 24 Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is Installed with Two Controllers)
1
2 3
PSU#0
4 5 6
CM#0
8
"■ Controllers" (page
1
4 5 6
CM#0
7
7
PSU#1
8
109))
"■ Power Supply Units" (page
2 3 4 5
CM#1
PSU#1
7
98
114))
6
Operation Guide (Basic)