X85; Default Tolerance Setting - Konica Minolta CM-26dG Instruction Manual

… Default Tolerance Setting

„
Memo • The default tolerance is set to the following values when the instrument is shipped from the factory.
Lower limit: -1.00 / Upper limit: 1.00
Δx, Δy, Δz Lower limit: -0.01 / Upper limit: 0.01
Operating Procedure
1
Move the cursor to "Default tolerance", and then
press the [Confirmation] key.
The tolerance list screen is displayed.
2
Use [▲] or [▼] to move the cursor to the item to set,
and then press the [Confirmation] key.
The <Edit tolerance> screen is displayed.
3
Use [▲]/[▼] and [◀]/[▶] to move the cursor to the
item to set, and then press the [Confirmation] key to
change the setting.
• When the selected item is not currently checked,
pressing the [Confirmation] key causes the item to be
checked, after which the setting value can be changed.
• Press [◀] or [▶] to move the cursor to the setting value
area. Pressing the [Confirmation] key causes the
cursor to appear on the value. Press [▲] or [▼] to
change the value. Move the cursor between the digits of
the value by pressing [◀] or [▶].
Settings
{ x / y
{ Equation / MI
{ Other than the above : -20.00 to 20.00
• Press the [Confirmation] key to confirm every time the
setting of an item is changed.
4
After all settings have been configured, use [▲] or
[▼] to move the cursor to "OK", and then press the
[Confirmation] key.
The setting is confirmed and the screen returns to the <Edit
tolerance> screen.
5
Press [ESC] to return to the <Default data setup>
screen.
Start the procedure from the <Default data setup> screen.
: -0.2000 to 0.2000
: 0.00 to 20.00
2
74