Setting A Specimen - Konica Minolta CF-300 Instruction Manual

Setting a Specimen

WARNING
Do not use the CF-300 in places where flammable or combustible gases (gasoline fumes, etc.) are present.
Doing so may cause a fire.
Do not disassemble or modify the CF-300. Doing so may cause a fire or electric shock.
Take special care not to allow liquid or metal objects to enter the instrument.
Doing so may cause a fire or electric shock. Should liquid or metal objects enter the
instrument, turn the power OFF immediately, disconnect the AC adapter plug from the
AC outlet, and contact the nearest Konica Minolta-authorized service facility.
CAUTION
Do not perform measurement with the specimen measuring port directed
towards your face. Doing so may cause damage to your eyes.
Be careful around openings in the CF-300. Failure to do so may
result in fingers being trapped causing injury.
c Attach the target mask that is to be used in measurements to the instrument before performing calibration.
Procedure
1
. Remove the finder cap.
2
. <For contact measurements>
Face the part of the specimen that is to be
measured towards the instrument and press it
flush against the instrument with your hand so
that it covers the specimen measuring port.
<For noncontact measurements>
Face the part of the specimen that is to be
measured towards the instrument and
immobilize it 1 mm from the specimen
measuring port so that it covers the specimen
measuring port.
3
. Look into the finder to verify that the
measurement point is properly positioned for
measurement.
Memo If using the optional SpectraMagic DX, the pointer
LED can be used to verify that the measurement
point is properly positioned for measurement.
4
. Attach the finder cap.
20