X85; Set Group - Konica Minolta CM-26dG Instruction Manual

… Set group

„
In order to facilitate classification of targets into groups, up to five groups to which data should be categorized can
be configured. After the targets have been registered to a group, the filtering function can be used to display only
the selected target data. This section describes the registration of a group.
Memo • If a new target is measured, the measurement will be assigned to the appropriate group according to the default
settings.
• Display the group of the target to be set on the <Target> screen in advance.
Operating Procedure
1
Use [▲] or [▼] to move the cursor to "Set group",
and then press the [Confirmation] key.
The <Edit group> screen is displayed.
2
Use [▲] or [▼] to move to the cursor to the group
number column to which the current target should
be applied, and then press the [Confirmation] key.
3
Use [▲] or [▼] to move the cursor to select the
group value to which the target should be applied,
and then press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Target> screen.
Memo
Group names configured in advance through <Default data
setup> in accordance with group numbers are displayed.
4
Select "OK". Selecting "Cancel" will cause the
display to return to the <Data management> screen
without changing the settings.
Notes
If [ESC] is pressed without pressing the [Confirmation]
key, the settings will not be changed and the screen will
return to the <Data management> screen.
Start the procedure from the <Target menu> - <Data management> screen.
2
64