X85; Manual Average (1 To 30) - Konica Minolta CM-26dG Instruction Manual

… Manual average (1 to 30)

„
Specify the number of measurements for manual averaging. The average of the data obtained from the measurements
conducted by pressing the measurement button the specified number of times is determined as sample data.
Memo
"1" is set as the number of measurements for manual averaging when the instrument is shipped from the factory.
Operating Procedure
1
Use [▲] or [▼] to move the cursor to "Manual
average", and then press the [Confirmation] key.
2 ▲ and ▼ will be displayed above and below the
count in the count selection. Use [▲] or [▼] to
specify a value.
Settings
{ 1 to 30 times:
Specify the number of measurements, from 1 to 30, to
perform when using manual averaging.
3
Press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Measurement setup> screen.
Notes
If [ESC] is pressed without pressing the [Confirmation]
key, the settings will not be changed and the screen will
return to the <Measurement setup> screen.
With manual average measurement, measurement is
performed for the configured number of times the
measurement button is pressed, and the average value of
those measurements is saved as a single measurement.
Selecting "Undo" after a measurement allows users to
perform the previous measurement again.
After the set number of measurements has been
performed, the average can be saved by selecting "Save".
To save the average automatically after the set number of
measurements has been performed, select "Auto save"
under "Measurement cond." - "Measurement setup" -
"Manual average option".
Start the procedure from the <Measurement cond.> - <Measurement setup> screen.
3
88