Job Function - Konica Minolta CM-26dG Instruction Manual

„ JOB Function
Administrators can pre-register to the instrument workflows to be performed by the worker, allowing the worker to perform
measurement according to the registered workflow. This selection screen is available when the job has been set in advance with
the optional Color Management Software SpectraMagic NX.
Notes
• Communication via USB is recommended when configuring JOB settings using the optional Color Management
Software SpectraMagic NX. Configuration of the JOB function is possible via Bluetooth communication, but
transferring settings and images between the computer and the measuring instrument will take time.
• Exiting JOB mode will cause the observation conditions under JOB settings to be reset and the main unit's
observation conditions to be restored. As such, if the JOB setting observation conditions differ from the main unit
observation conditions, pass/fail results may differ between during JOB execution and after exiting the mode.
Operating Procedure
1
Press [MENU], and then use [◀] or [▶] to display the
<JOB> screen.
Memo
To return to the previous screen, press [MENU] or [ESC].
2
Use [▲] or [▼] to move the cursor to the job to be
used.
3
Follow the on-screen instructions to perform
measurement.
Notes
• Up to 5 types of jobs can be registered.
• Calibration according to the measurement conditions
being used within the job must be performed in
advance.
Opacity measurement cannot be performed while in
JOB mode.
The operations for the various keys on the instrument are as
follows.
• [▲] / [▼] key ... Used to switch the data display type
(SCI, SCE, or Pass or Fail).
• [◀] / [▶] ... Used to select the Option Item.
• [Confirmation] key... Used to execute the Option Item
selected by the cursor.
• [Target/Sample] key ...
Operation step : Disabled
Result step : Disabled
• [Menu] ... Disabled
• [ESC] key ... Used to end a job in progress through a warning
message. Users can select "YES" or "NO" for the warning.
Selecting "YES" will cause the screen to return to the JOB
selection screen. Selecting "NO" will maintain the current
step.
• [MES] key ...
Operation step : Performs measurement and moves to the
next step.
Result step : Moves to the next step.
Start the procedure from the measurement screen.
<Operation step>
<Result step>
• << ... Moves to the previous step. When
returning to the Operation step, the
data measured in the Operation step
will be discarded, so performing
measurement again will be
necessary.
• > ... Moves to the next step. This key is
not displayed in the Operation step.
• >> ... Moves to the next Operation step.
4
132