Abs (Anti-Lock Brake System) Final Check - Yamaha R1 Series 2015 Service Manual

EAS31168
[C-1] FINAL CHECK
Check all the following items to complete the inspection.
If the process is not completed properly, start again from the beginning.
Checking procedures
1. Check the brake fluid level in the brake master cylinder reservoir and brake fluid reservoir.
Refer to "CHECKING THE BRAKE FLUID LEVEL" on page 3-14.
2. Check the wheel sensors for proper installation.
Refer to "INSTALLING THE FRONT WHEEL (DISC BRAKE)" on page 4-31 and "INSTALLING THE
REAR WHEEL (DISC BRAKE)" on page 4-40.
3. Perform brake line routing confirmation.
Refer to "HYDRAULIC UNIT OPERATION TEST" on page 4-70.
If it does not have reaction-force properly, the brake hose is not properly routed or connected.
4. Delete the fault codes.
Refer to "[B-3] DELETING THE FAULT CODES" on page 8-150.
5. Checking the ABS warning light.
Refer to "CHECKING THE ABS WARNING LIGHT" on page 4-73.
If the ABS warning light does not turn off, the possible causes are following:
• The problem is not solved.
• Open circuit between the ABS ECU and the meter assembly.
Check for continuity between green/orange terminal of the ABS ECU coupler and green/orange ter-
minal of the meter assembly coupler.
• Malfunction in the meter assembly circuit.
• Malfunction in the ABS warning light circuit in the hydraulic unit assembly.
ABS (Anti-lock Brake System)
1
8-151