Yamaha R1 Series 2015 Service Manual page 151

1. Brake hose (front brake master cylinder to
hydraulic unit)
2. Clamp
3. Brake hose (hydraulic unit to front brake cali-
pers)
4. Front wheel sensor lead
5. Front brake caliper
6. Front wheel sensor
7. Front fork
8. Front brake hose holder
9. Front brake master cylinder
10.Front brake hose bracket
11.Front wheel sensor lead holder
12.Front wheel sensor protector
13.Plastic locking tie
A. When installing the brake hose onto the mas-
ter cylinder, make sure the projection on the
brake hose touches the projection on the
master cylinder.
B. Install the clamp with the opening facing for-
ward.
C. Install the clamp to the top side of the rim on
the brake hose.
D. Route the front wheel sensor lead along the
brake hose (left) without any slack.
E. Fasten the front wheel sensor lead at the
white tape with the holder.
F. Install the clamp to the brake hose at the tube
section.
G. For YZF-R1M
H. Rear side of the vehicle
I. Cut off the excess end of the plastic locking
tie to 5 mm (0.2 in) or less. The end of the
plastic locking tie may be pointing in any
direction.
J. Front side of the vehicle
K. Position the buckle of the plastic locking tie
10 mm (0.39 in) or more from the brake hose.
L. Route the front wheel sensor lead through
the guide of the front wheel sensor protector.
2-76
CABLE ROUTING