Yamaha R1 Series 2015 Service Manual page 378

bolt.
15mm pin type rotor holding tool
90890-04171
YM-04171
3
3. Apply:
• Sealant
(onto the stator coil assembly lead grommet)
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
4. Install:
• Generator cover gasket
• Generator cover
• Generator cover bolt
Generator cover bolt
1st: 6 Nm (0.6 m·kgf, 4.3 ft·lbf)
*
2nd: 3.0 Nm (0.30 m·kgf, 2.2
ft·lbf)
Specified angle 90
*
Following the tightening order, loosen the bolt
one by one and then retighten it to the specific
torque and the specific angle.
TIP
Tighten the generator cover bolts in the tighten-
ing sequence as shown.
2
1
New
New
7
6
5
4
5. Connect:
• Stator coil coupler
• Crankshaft position sensor coupler
TIP
To route the stator coil lead, refer to "CABLE
ROUTING" on page 2-51.
5-37
GENERATOR
8
1
2
3