Yamaha R1 Series 2015 Service Manual page 149

1. Hydraulic unit
2. Rear frame
3. Brake fluid reservoir
4. Frame
5. Brake hose (rear brake master cylinder to
hydraulic unit)
6. Rear wheel sensor lead
7. Rear brake master cylinder
8. Swingarm assembly
9. Rear wheel sensor lead cover
10.Rear wheel sensor protector
11.Rear wheel sensor
12.Rear brake caliper
13.Brake hose (hydraulic unit to rear brake cali-
per)
14.Brake fluid reservoir hose
15.Hydraulic unit brake pipe (rear brake master
cylinder to hydraulic unit)
16.Hydraulic unit brake pipe (hydraulic unit to
rear brake caliper)
17.Rear brake hose bracket
18.Clamp
19.Hook
20.Brake caliper bracket
21.Rear brake hose holder
22.Rear fender
A. Install the clamp 0–10 mm (0–0.39 in) from
the slit of the brake hose protector.
B. Make sure that the rear wheel sensor lead
does not protrude from the rear wheel sensor
lead cover.
C. Route the rear wheel sensor lead between
the swing arm assembly and rear wheel sen-
sor lead cover.
D. 65.4
E. 58.6
F. Position the rear wheel sensor lead at the
back.
G. Install the clamp at a position 0–10 mm (0–
0.39 in) from the top edge of the brake hose
protector.
H. Fasten the rear wheel sensor lead at under
the white tape with the clamp.
I. Fasten the brake hose (rear brake master cyl-
inder to hydraulic unit) at the metal fitting with
large inner diameter side of the clamp.
J. Install the grommet of the rear wheel sensor
lead securely to the hook.
When installing the grommet on the rear
wheel sensor lead, may apply silicone fluid or
soapy water to the grommet.
K. Install the grommet of the rear wheel sensor
lead securely to the claw of the rear wheel
sensor lead cover.
When installing the grommet on the rear
wheel sensor lead, may apply silicone fluid or
soapy water to the grommet.
L. Install the grommet of the rear wheel sensor
lead securely to the rear wheel sensor pro-
tector.
When installing the grommet on the rear
wheel sensor lead, may apply silicone fluid or
soapy water to the grommet.
M. Install the rear wheel sensor lead securely to
the claw of the rear wheel sensor protector.
N. Route the brake hose between the rear brake
hose holder and swing arm assembly.
O. Fasten the brake hose with the clamp.
2-74
CABLE ROUTING