b. Turn the front wheel 90 so that the heavy
spot is positioned as shown.
c. If the heavy spot does not stay in that posi-
tion, install a heavier weight.
d. Repeat steps (b) and (c) until the front wheel
is balanced.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4. Check:
• Front wheel static balance
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the front wheel and make sure it stays at
each position shown.
b. If the front wheel does not remain stationary
at all of the positions, rebalance it.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30154
INSTALLING THE FRONT WHEEL (DISC
BRAKE)
1. Install:
• Plate
• Front brake discs
Front brake disc bolt
17 Nm (1.7 m·kgf, 12 ft·lbf)
LOCTITE®
ECA19150
NOTICE
Replace the brake disc bolts with new ones.
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
LT
2. Apply:
• Sealant
TIP
Apply Three Bond No. 1215B® onto the corner
of brake disc and wheel.
3. Check:
• Front brake discs
Refer to "CHECKING THE FRONT BRAKE
DISCS" on page 4-48.
4. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
5. Install:
• Collar
• Front wheel
• Front wheel axle
• Front wheel axle nut
TIP
Apply lithium soap-based grease onto the mat-
4-31
FRONT WHEEL