Yamaha R1 Series 2015 Service Manual page 471

center button "2" for 2 seconds or more.
TIP
The diagnostic code number "01" appears on
the display.
LCS QS LIF
1000 r/min
×
01
DIAG
16
DATA
MODE - A
ETV
i. Diagnostic code number "14" is selected.
j. Turn the throttle grip to the fully closed posi-
tion.
k. Adjust the position of the accelerator position
sensor angle so that 12–22 can appear in the
meter.
l. After adjusting the accelerator position sen-
sor angle, tighten the accelerator position
sensor screws "6".
Accelerator position sensor
screw
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
m. Turn the throttle grip to the fully open position.
n. Check the meter display value. If the meter
display value is not 97–107, adjust the accel-
erator position sensor angle.
1
2
12 : 00
A-1 GPS
km/h
N
1 2
km
km
1 1 1
TCS SCS
6
o. Select the diagnostic code number "15".
p. Turn the throttle grip to the fully closed posi-
tion.
q. Check the meter display value. If the meter
display value is not 10–24, adjust the acceler-
ator position sensor angle.
r. Turn the throttle grip to the fully open position.
s. Check the meter display value. If the meter
display value is not 95–109, adjust the accel-
erator position sensor angle.
t. Repeat steps (i) to (s) until the meter display
values are within the specified ranges.
u. If the meter display values are not within the
specified ranges after repeating steps (i) to
(s) several times, replace the accelerator po-
sition sensor.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6
7-18
THROTTLE BODIES