Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips; Rubber Parts - Yamaha R1 Series 2015 Service Manual

Table of Contents

LOCK WASHERS/PLATES AND COTTER

After removal, replace all lock washers/plates

"1" and cotter pins. After the bolt or nut has been

tightened to specification, bend the lock tabs

along a flat of the bolt or nut.

Install bearings "1" and oil seals "2" so that the

manufacturer marks or numbers are visible.

When installing oil seals, lubricate the oil seal

lips with a light coat of lithium-soap-based

grease. Oil bearings liberally when installing, if

appropriate.

Do not spin the bearing with compressed air

because this will damage the bearing surfac-

Before reassembly, check all circlips carefully

IMPORTANT INFORMATION

and replace damaged or distorted circlips. Al-

ways replace piston pin clips after one use.

When installing a circlip "1", make sure the

sharp-edged corner "2" is positioned opposite

the thrust "3" that the circlip receives.

Check rubber parts for deterioration during in-

spection. Some of the rubber parts are sensitive

to gasoline, flammable oil, grease, etc. Do not al-

low any items other than the specified one to

contact the parts.

Troubleshooting