Assembling The Front Wheel - Yamaha R1 Series 2015 Service Manual

2. Check:
• Tire
• Front wheel
Damage/wear Replace.
Refer to "CHECKING THE TIRES" on page
3-17 and "CHECKING THE WHEELS" on
page 3-17.
3. Measure:
• Radial wheel runout "1"
• Lateral wheel runout "2"
Over the specified limits
Radial wheel runout limit
1.0 mm (0.04 in)
Lateral wheel runout limit
0.5 mm (0.02 in)
4. Check:
• Wheel bearings
Front wheel turns roughly or is loose
place the wheel bearings.
• Oil seals
Damage/wear Replace.
Replace.
Re-
4-28
EAS30151

ASSEMBLING THE FRONT WHEEL

ECA21340
NOTICE
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Install:
• Wheel bearings
New
• Oil seals
New
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install the new wheel bearing (right side).
ECA18110
NOTICE
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
TIP
Use a socket "4" that matches the diameter of
the wheel bearing outer race.
b. Install the spacer.
c. Install the new wheel bearing (left side).
TIP
Place a suitable washer "1" between the socket
"2" and the bearing so that both the inner race
"3" and outer race "4" are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer "5".
d. Install the new oil seals.
FRONT WHEEL