Yamaha R1 Series 2015 Service Manual page 313

1
8. Install:
• Dust seal "1"
(with the fork seal driver "2")
Fork seal driver
90890-01442
Adjustable fork seal driver (36–46
mm)
YM-01442
2
1
9. Install:
• Rod puller "1"
(onto the damper rod "2")
Front fork rod puller M7x0.75
90890-01576
YM-01576
10.Fill:
• Front fork leg
(with the specified amount of the recom-
mended fork oil)
1
2
4-96
FRONT FORK (for YZF-R1M)
Recommended oil
YZF-R1M Suspension oil M1 or
Ohlins R&T 43
Quantity
YZF-R1M 405.0 cm³ (13.69 US oz,
14.28 Imp.oz)
ECA14230
NOTICE
• Be sure to use the recommended fork oil.
Other oils may have an adverse effect on
front fork performance.
• When disassembling and assembling the
front fork leg, do not allow any foreign ma-
terial to enter the front fork.
11.After filling the front fork leg, slowly stroke the
damper rod "1" up and down (at least ten
times) to distribute the fork oil.
TIP
Be sure to stroke the damper rod slowly be-
cause the fork oil may spurt out.
12.Before measuring the fork oil level, wait ten
minutes until the oil has settled and the air
bubbles have dispersed.
TIP
Be sure to bleed the front fork leg of any residual
air.
13.Measure:
• Front fork leg oil level "a"
(from the top of the outer tube, with the outer
tube fully compressed and without the fork
spring)
Out of specification
Level
YZF-R1M 220.0 mm (8.66 in)
1
Correct.