Yamaha R1 Series 2015 Service Manual page 305

a
2. Tighten:
• Lower bracket pinch bolts "1" and "2"
Lower bracket pinch bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
TIP
Tighten each bolt to 23 Nm (2.3 m·kgf, 17 ft·lbf)
in the order pinch bolt "1"
pinch bolt "1" pinch bolt "2".
3. Tighten:
• Cap bolt "1"
Front fork cap bolt (for YZF-R1)
23 Nm (2.3 m·kgf, 17 ft·lbf)
• Handlebar bolt "2"
Handlebar bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
• Handlebar pinch bolt "3"
Handlebar pinch bolt
32 Nm (3.2 m·kgf, 23 ft·lbf)
• Upper bracket pinch bolt "4"
Upper bracket pinch bolt
26 Nm (2.6 m·kgf, 19 ft·lbf)
pinch bolt "2"
1
2
4-88
FRONT FORK (for YZF-R1)
3
TIP
When installing the front fork legs, make sure
that the spring preload adjusting nuts are posi-
tioned at the angles shown in the illustration.
55-65°
4. Check:
• Cable routing
TIP
Make sure the brake hose, throttle cables, clutch
cable, and handlebar switch leads are routed
properly. Refer to "CABLE ROUTING" on page
2-51.
5. Install:
• Plastic locking tie "1"
TIP
Fasten the front brake hose to the right front fork
leg with the plastic locking tie.
6. Adjust:
• Spring preload
• Rebound damping
• Compression damping
2
1
4
55-65°
1