Yamaha R1 Series 2015 Service Manual page 294

b
a
4. Install:
• Handlebar switch screw (right)
Handlebar switch screw
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
TIP
Align the projection "a" on the right handlebar
switch with the hole "b" in the handlebar.
5. Install:
• Front brake master cylinder assembly
Refer to "INSTALLING THE FRONT BRAKE
MASTER CYLINDER" on page 4-53.
6. Install:
• Clutch lever holder "1"
• Clutch cable
Clutch lever holder pinch bolt
11 Nm (1.1 m·kgf, 8.0 ft·lbf)
TIP
Align the center of slit on the clutch lever holder
with the punch mark "a" on the handlebar.
2
1
c
2
b
a
1
7. Install:
• Handlebar switch screw (left)
Handlebar switch screw
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
TIP
Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
b
8. Install:
• Handlebar grip "1"
• Grip end "2"
Grip end bolt
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
b. Side the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "a" between the handlebar grip and the grip
end.
4-77
HANDLEBARS
a
a