The Ecu Cannot Receive Fault Signals From The Imu - Yamaha R1 Series 2015 Service Manual

Fault code No. 98
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
Procedure
Item Probable cause of
malfunction and check
1 Connection of IMU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
2 Connection of wire harness
ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
3 Wire harness continuity.
4 Installed condition of IMU.
5 Defective IMU.
6 Malfunction in ECU.
98
The ECU cannot receive fault signals from the IMU, or it cannot
receive normal signals.
Able/Unable to start engine
Able/Unable to drive vehicle
—
—
—
Maintenance job
Improperly connected
nect the coupler securely or
replace the wire harness.
Improperly connected
nect the coupler securely or
replace the wire harness.
Open or short circuit
the wire harness.
Between ECU coupler and joint
coupler.
blue/white–blue/white
blue/black–black/blue
Between joint coupler and IMU
coupler.
blue/white–blue/white
blue/black–black/blue
Check the installed direction
and condition of the sensor.
Check the grommet for cracks.
Replace the IMU.
Replace the ECU.
Refer to "REPLACING THE
ECU (Engine Control Unit)" on
page 8-180.
8-101
FUEL INJECTION SYSTEM
Confirmation of service com-
Con- Turn the main switch to "ON".
Fault code number is not dis-
played Service is finished.
Fault code number is displayed
Go to item 2.
Con- Turn the main switch to "ON".
Fault code number is not dis-
played Service is finished.
Fault code number is displayed
Go to item 3.
Replace Turn the main switch to "ON".
Fault code number is not dis-
played Service is finished.
Fault code number is displayed
Go to item 4.
Turn the main switch to "ON".
Fault code number is not dis-
played Service is finished.
Fault code number is displayed
Go to item 5.
Turn the main switch to "ON".
Fault code number is not dis-
played Service is finished.
Fault code number is displayed
Go to item 6.
pletion