Moving Your Printer; Removing The Maintenance Tray - Tektronix Phaser 340 User Manual

Appendix
C

Removing the maintenance tray

Moving Your Printer

Before turning off the printer, wait for it to display the Ready message.
Turn off the printer using the rear-panel On/Off switch.
Caution
To avoid damaging the printer, let the printer cool down for at
least 30 minutes before you move it so that the ink has time to
solidify.
Before you move the printer, you'll want to complete the steps presented in
this chapter.
1. Remove the maintenance tray from the printer, keeping it level.
Remove, empty, and replace the waste tray. Refer to "Emptying
the waste tray" on page 4-5 for detailed instructions.
2. Place the maintenance tray in a plastic bag and seal the bag.
The maintenance tray contains drum fluid that leaks if the tray is
tipped. Keep the maintenance tray level and in a sealed plastic
bag while transporting it.
Caution To avoid damaging your printer and invalidating your
printer's warranty, remove the maintenance tray before
moving the printer. Always store a used maintenance tray in a
leak-proof package. When handling the maintenance tray, keep
it level. Never ship a partially used maintenance tray. Contact
with the drum fluid poses no known health risk. Refer to
"MSDS for silicone oil" on page D-7 for more information.
C-1
User Manual