Tektronix Phaser 340 User Manual page 103

2.
When you open the front cover, the following message appears:
Waste Tray Full
Remove Maintenance Tray
3.
Grasp the maintenance tray by the front edge and lift up while
sliding it out of the printer.
Note Once the maintenance tray has been partially used, it will leak
drum fluid if tipped. Place the maintenance tray on a flat surface
after removing it from the printer. Contact with the drum fluid
poses no known health risk. Refer to "MSDS for silicone oil" on
page D-7 for more information.
Caring for Your Printer
9101-53
4-5
User Manual
4