Connecting Multiple Disks - Tektronix Phaser 340 User Manual

Connecting multiple disks

Caution
To avoid damaging components, turn off the computer, printer,
and external disk before you connect or disconnect a SCSI
cable. Turn on the disks before you turn on the printer.
1. SCSI port
2.
External disks
3. Terminator (not required if the end disk has a built-in terminator if
you have a Phaser Copystation connected at the other end of the
chain). The middle disk must not have an internal terminator).
Each disk must have a unique SCSI ID number. Do not turn on the printer or
disk until each disk has a unique number.
Note See "Interface cables and adapters" on page 5-3 for cable ordering
information.
1
Ethernet® PHASER 340
Service SCSI Disk
Only
Expanding Your Printing System
1 2
Service Reset
Second
Feeder
Parallel
SCSI
B
2 3
SCSI
9101-44
B-11
User Manual