Tektronix Phaser 340 User Manual page 154

Front panel messages (cont'd.)
Message
Cleaning
Waiting For Manual
Feed
Waiting For
Transparency
Waiting For Paper
Upper Media Tray
Empty
Media Tray Empty
Lower Media Tray
Empty
Replace Upper
Media Tray
Replace Media Tray
Replace Lower
Media Tray
Incorrect Media
Size
Manual Feed Paper
Fault. Service
Required
Action
No user action required. The printer is running an
automatic cleaning operation.
Insert paper or transparency in the manual feed slot.
The print job specifies transparency but the printer
detects that the paper tray is installed. Load
transparency in the media tray and press
The print job specifies paper but the printer detects that
the transparency tray is installed. Load paper in the
media tray and press OK .
Add paper or transparencies to the standard media
tray.
Add paper or transparencies to the media tray.
Add paper to the lower media tray.
Insert the standard media tray.
Insert the standard media tray.
Insert the lower media tray.
An incorrect paper size is loaded in the tray or paper
narrower than A4-size is in the manual feed slot. Use
Letter- or A4-size media.
The printer requires a sheet of paper for cleaning but
the media tray contains transparency. Feed a sheet of
paper into the manual feed slot.
Turn the printer off, wait at least 15 seconds and turn
the printer's power on again. If the failure persists, note
the code number in the display. In the U.S., call
Tektronix service at 1-800-835-6100. Outside the U.S.,
contact your local Tektronix office.
Troubleshooting
OK
.
6-9
User Manual
6