Cleaning For Light Stripes: Printhead - Tektronix Phaser 340 User Manual

4
Caring for Your Printer

Cleaning for light stripes: printhead

4-18
Phaser 340 Color Printer
Approximate time to complete: 3-10 minutes
If your prints have 1/10 in. (2.5 mm) lengthwise stripes that are the wrong
color or have missing colors, you can correct the problem by cleaning the
printhead. The printer automatically executes a printhead cleaning
sequence when you run the Clean:Light Stripes routine from the front
panel.
1.
When the printer is on and the Ready message appears, press the
Clean button. The printer displays the first selection in the menu:
Clean:Light Stripes
<---- Clean
2. Press the Clean button once again.
3.
A series of front panel messages indicate the condition of the
printer as it progresses through a sequence of automatic cleaning
routines. The printer outputs a cleaning page at the end of the
cleaning sequence that you may discard as normal office waste.
4. When the cleaning sequence is completed, the printer displays the
following message:
Clean:Light Stripes
<---- Clean
A
9101-48
Test
Test