Replacing The Maintenance Tray - Tektronix Phaser 340 User Manual

Replacing the maintenance tray

Approximate time to complete: 1 minute
The printer uses the maintenance tray, located inside the printer behind the
front cover, prior to each printing and during cleaning operations. A front
panel message tells you when the maintenance tray is low, allowing you to
make a minimal number of prints before the tray is depleted. Install a new
maintenance tray to continue printing. Each replacement maintenance tray
has a print capacity of approximately 10,000 prints. To avoid printing
delays, keep an extra maintenance tray available for use in the printer.
Note
There is a 15-minute warm-up period required after replacing the
maintenance tray.
To order a maintenance tray (Tektronix order number 436-0294-03), contact
your local dealer or, in the United States, call Tektronix at 1-800-835-6100.
1. Open the front cover.
Caution Some surfaces inside the printer may be hot. Be careful not to
touch the areas marked with this caution icon:
Caring for Your Printer
9101-22
4-7
User Manual
4