Tektronix Phaser 340 User Manual page 153

6
Troubleshooting
6-8
Phaser 340 Color Printer
Front panel messages (cont'd.)
Message
Jam:Open Front
Cover
Jam:Retry Manual
Feed
Jam:Open Exit
Cover
Jam:Remove Upper
Tray
Jam:Remove Lower
Tray
Jam:Remove Media
Tray
Ink Low/Out of Ink
Maintenance Tray
Low
Replace
Maintenance Tray
Maintenance Tray
Missing
Maintenance Tray
Locked
Waste Tray Full
Standby
Energy Star Mode
Action
Open the front cover and remove the paper jam from
the manual feed slot or behind the front cover. You may
need to push on both sides of the maintenance tray to
relatch it or clean the upper or lower paper feed rollers.
Remove the media from the manual feed slot and
re-insert it.
Open the exit cover and remove the paper jam. You
may need to clean the paper exit path.
There is a paper jam at the standard media tray.
Remove the tray and the jammed paper. You may need
to run the Clean:Paper Jams routine.
There is a paper jam at the lower paper tray. Remove
the tray and the jammed paper.
There is a paper jam at the paper tray. Remove the tray
and the jammed paper. You may need to run the
Clean:Paper Jams routine.
The Ink Low message appears when ink level drops to
one-half stick. Open the top cover and add the
appropriate color of ColorStix solid ink stick.
The Maintenance Tray Low message appears when
the tray is nearly empty. Open the front cover, remove
the maintenance tray, and replace it with a new one.
Open the front cover, remove the maintenance tray,
and replace it with a new one.
Insert a maintenance tray into the printer.
The printer has locked the maintenance tray because
hot ink is present. Wait for a few minutes before trying
to remove the maintenance tray.
Open the front cover, remove the maintenance tray and
empty the waste tray.
Press Wakeup or send a print job to bring the printer
to Ready.
Press Wakeup or send a print job to bring the printer
to Ready.