Replacing The Maintenance Tray - Tektronix Phaser 360 User Manual

Replacing the maintenance tray

The maintenance tray is a disposable unit located inside the printer and
behind the front cover. It cleans the printerÕs drum, contains the waste liner
(a blue plastic insert) for used ink, and functions in other operations of the
printer.
A front panel message tells you when the maintenance tray is low. Install a
new maintenance tray to continue printing. Each replacement maintenance
tray has a print capacity of approximately 12,500 prints. To avoid printing
delays, keep an extra maintenance tray available for use in the printer.
Refer to ÒPrinter suppliesÓ on page 10-2 for information on
ordering the maintenance tray.
Note
There is a 15-minute warm-up period required after replacing the
maintenance tray.
Open the front cover.
1.
Caring For Your Printer
9922-123
7-11
User Manual
7