Toro Groundsmaster 4300-D Service Manual page 60

Installing the Engine (continued)
Diesel Engine: Service and Repairs
C. The engine wire harness power cable to the battery clamp through the
cord grip and tighten the cord grip.
D. The negative battery cable, engine wire harness ground cable and frame
to engine ground cable at the engine block
g190801
1. Hydraulic pump driveshaft
2. EGR relay
3. Start relay
E. The engine wire harness connectors to the main power, glow, start, and
EGR relays (Figure
F. The engine wire harness connector to the fuel pump.
G. The 2 engine wire harness connectors from the engine ECU.
7. Use the notes that you recorded during removal, secure the wires with cable
ties in proper locations.
8. Remove all of the covers and plugs from the hoses and engine openings that
you placed while removing the engine. Connect the hoses to the engine:
A. Use the labels that you attached during removal to correctly connect the
fuel supply and return hoses to the fuel filter on the engine
Secure the fuel hoses with the hose clamps.
B. Connect the upper and lower radiator hoses to the engine. Secure the
radiator hoses with the hose clamps.
9. Install the air cleaner assembly; refer to
(page 3–11).
10. Install the exhaust system to the machine; refer to
System (page 3–14). Ensure that the exhaust tube has 9.5 mm (0.375 inch)
clearance with tailpipe guard in all directions after assembly.
11. Ensure that the radiator draincock is closed and fill the radiator and reservoir
with coolant.
12. Connect both the battery cables to the battery. First, connect the positive
battery cable and then the negative battery cable; refer to
Battery (page 5–94).
Figure 20
4. Glow relay
5. Main power relay
20).
Installing the Air Cleaner System
Page 3–28
(Figure 18).
(Figure
Installing the Exhaust
Servicing the
Groundsmaster
16226SL Rev C
17).
® 4300-D