Toro Groundsmaster 4300-D Service Manual page 342

Installing the Rear Axle Motor Housings (continued)
Chassis: Service and Repairs
6. Slide the wheel motor assembly (with the wheel hub and hydraulic hoses
attached) into the motor housing. Secure the wheel motor to the motor
housing with the 4 bolts and 4 lock washers; torque the bolts to 109 to 135
N∙m (80 to 100 ft-lb).
7. Clean the tapered surfaces of both mating parts before installation, connect
the tie rod end (item 22 in
nut and cotter pin.
8. If the right side motor housing was removed, clean the tapered surfaces of
both mating parts before installation, and secure the steering cylinder ball
joint (item 25 in Figure
cotter pin.
9. Lubricate the motor housing shafts through the grease fittings on the rear
axle.
10. Install the rear wheel assembly; refer to
11. Check the rear wheel toe-in; refer to the Operator's Manual.
12. Ensure that there is no contact between the machine components including
hydraulic hoses while the rear wheels move from lock to lock. Adjust if
necessary.
Figure 209) to the drag link with the slotted hex
209) to the drag link the with the slotted hex nut and
Installing the Wheel (page
Page 6–18
6–6).
Groundsmaster ® 4300-D
16226SL Rev C