Toro Groundsmaster 4300-D Service Manual page 353

Removing the Mechanical Seat Suspension
Groundsmaster ® 4300-D
16226SL Rev C
g185934
1. Seat adjuster w/latch
2. Seat adjuster
3. Flat washer (4 each)
4. Flange-head screw (4 each)
5. Flange nut (8 each)
6. R-clamp (2 each)
7. Spacer (4 each)
1. Park the machine on a level surface, lower the cutting decks, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Remove the seat from the machine; refer to
(page 6–26).
Do not damage the platform wire harness when removing the seat
suspension from the machine.
3. Tilt and support the seat frame to get access to the seat suspension fasteners.
4. Support the seat suspension to prevent it from falling.
5. Record which set of mounting holes are used, remove the 4 flange-head
screws (item 4 in Figure
suspension to the seat frame.
6. Remove the seat suspension from the machine.
7. Locate and retrieve the 4 spacers (item 7 in
suspension and seat frame.
8. Remove the seat suspension components as necessary
Figure 219). If the seat adjusters are being removed, record the seat adjuster
mounting holes used.
Figure 219
8. Manual tube
9. Seat base cover
10. Seat frame
11. Bolt (4 each)
12. Seat suspension bracket (2 each)
13. Seat suspension
IMPORTANT
219) and 4 flange nuts that secure the seat
Page 6–29
Removing the Operator Seat
Figure 219) from the seat
(Figure 218
Chassis: Service and Repairs
and