Toro Groundsmaster 4300-D Service Manual page 59

Removing the Engine (continued)
Installing the Engine
Groundsmaster ® 4300-D
16226SL Rev C
12. Carefully raise the engine from the machine moving it toward the front of the
machine and away from the radiator assembly.
13. If necessary, remove the engine mount brackets from the engine.
Ensure that all parts are removed from the engine during
maintenance or overhaul are correctly installed on the engine.
1. If the engine mount brackets were removed from the engine, secure the
brackets to the engine with the lock washers and bolts. Torque the bolts to
46 to 57 N∙m (34 to 42 ft-lb).
The engine is very heavy, and a hoist not rated for the weight of the
engine may fail, causing possible injury and damage to the engine.
Use hoist equipment rated to lift the engine, which is approximately
200 kg (441 lb).
2. Attach a suitable lift or hoist to the lift tabs on the front and rear of the engine.
Support the engine with lift or hoist to prevent the engine from shifting or
moving.
Use 1 person to operate the lift or hoist while the other person
guides the engine into the machine.
When installing the engine ensure that you do not damage the
engine, fuel hoses, hydraulic lines, electrical harness, radiator or
other parts.
3. Carefully lower the engine into the machine. Ensure that the fastener holes
of the engine mount brackets aligned with the holes in the engine mounts.
4. Insert the bolt down through each engine mount bracket and engine mount.
Install the spacer, snubbing washer, and flange nut on the 4 bolts. Tighten
the fasteners to secure the engine to the engine mounts.
5. Install the hydraulic pump driveshaft; refer to
(page 4–98).
6. Connect the wire harness connectors to the following engine components:
A. The 2 engine wire harness connectors to the machine wire harness.
B. The positive battery cable to the engine starter motor.
IMPORTANT
CAUTION
CAUTION
IMPORTANT
Page 3–27
Hydraulic Pump Driveshaft
Diesel Engine: Service and Repairs