Servicing The Rear Roller - Toro Groundsmaster 4300-D Service Manual

Servicing the Rear Roller

Disassembling the Rear Roller
Groundsmaster ® 4300-D
16226SL Rev C
g195108
1. Roller tube
2. Roller shaft
3. Inner seal
4. Bearing
g195710
1. Roller tube
2. Inner seal
1. Remove the bearing locknut from each end of the roller shaft.
2. Loosely secure the roller assembly in a bench vise and lightly tap one end of
the roller shaft until the outer seals and bearing are removed from opposite
end of the roller tube. Remove the second set of outer seals and bearing
from the roller tube by tapping on opposite end of the shaft. Remove the
shaft from the roller tube.
3. Carefully remove the inner seal from both ends of the roller tube, ensure that
you do not damage the tube surfaces.
4. Discard the seals and bearings that were removed.
Figure 236
5. Outer seal
6. Bearing locknut
7. Set screw
Figure 237
3. Inner seal tool
Page 7–17 Cutting Deck: Service and Repairs