Toro Groundsmaster 4300-D Service Manual page 292

Testing the Mow/Transport Switch (continued)
Electrical System: Testing the Electrical Components
D. Turn key switch to the R
with a multimeter that the platform wire harness connector terminal for
pink wire has system voltage (12 VDC) present.
E. If the black wire is closed to the ground, the pink wire has system voltage
present, and the switch LED did not function, replace the mow/transport
switch. Adjust the switch after installation; refer to
Mow/Transport Switch (page
8. If the mow/transport switch testing is correct and a circuit problem still exists,
check the platform wire harness; refer to the Electrical Schematic and Wire
Harness Drawings/Diagrams in
9. After you complete the mow/transport switch testing, ensure that the switch
connector is plugged into platform wire harness.
position (do not start the engine) and check
UN
5–44).
Appendix A (page
Page 5–68
Adjusting the
A–1).
Groundsmaster ® 4300-D
16226SL Rev C